Quickly and easily deploy your kicker motor by flipping a switch with the Model 45 Motor Lift. Improvements for 2019 for this already impressive motor lift allow for 20% faster travel from fully raised to deployed position. With 15.5" of vertical lift, the Model 45 is perfect for boats where a clamp-on kicker motor will be mounted to a tall transom. Rugged construction features 1/4" thick fabricated aluminum plates, heavy-duty black powder-coat paint, and stainless steel hardware. This 12 volt Electro/Hydraulic system includes all wiring (25'), relays and a dash-mounted rocker switch.
Wireless Option Available
Make your day on the water just a bit more enjoyable with out straining your muscles trying to raise and lower the auxiliary motor. A simple convenience with major results. The heavy duty bracket easily handles auxiliary outboards up to 35hp or 150 pounds. Kicker motors are supported in any position with this durable design. In addition to its ruggedness, the Model 35 is the only kicker motor lift with a convertible setback. This unit can be adjusted to 13 inches of setback, making it ideal for inboards, I/Os, jet-drives, and outboards when over the transom mounting is unavailable.
An optional spacer (55-9035) offers an additional three inches of setback for even greater clearance. When it comes to auxiliary motor lifts, the Model 35 sets the standard. Rugged, reliable, and tournament tested.
55-0035 Spec Sheet
This trim and tilt is designed specifically for the weekend fisherman. The Model 40 is a heavy duty fabricated aluminum bracket. It will hold 2 and 4 strokes motors up to 150lbs. It’s powerful electro-mechanical actuator provides automatic trim and tilt with the push of a button. Bracket comes with electrical relay and 2 button switch (12ft cord).
7” setback - weighs 27 lbs
55-0040 Spec Sheet
Rugged Trim & Tilt for pontoons and other boats, the compact Trim & Tilt Model 55 conveniently matches outboards from 15hp to 55hp weighing up to 250 pounds. Perfectly designed for pontoons, fishing, or pleasure boats, the Trim & Tilt provides an additional five degrees of negative tuck for improved hole shot.
Adapts to clamp on or bolt-through outboards.
Standard BIA bolt pattern.
55-0055 Spec Sheet
Make your day on the water just a bit more enjoyable with out straining your muscles trying to raise and lower an outboard motor that is not equipped with trim and tilt. A simple convenience with major results. The model 135 is the perfect option for older outboard motors with bad hydraulic trim and tilts, when repair costs are prohibitively expensive.
The heavy duty bracket is designed for outboards up to 135hp or 350 pounds and it maximizes lifting power (even greater than the outboards tilt range), and it also allows for increased tuck-under to get heavy boats on plane quickly. Adapts to clamp on or bolt-through outboards.
55-0135 Spec Sheet